Sanivite: waste water pump for a dishwasher, washing machine, tumble dryer and sink in a kitchen or utility room
Sanivite makes the addition of a domestic kitchen or utility room easy even when below or distant from a drain.
Sanivite can also be used to drain a bath or shower (see Technote below)
Pumping waste water away through 32mm pipework, Sanivite offers vertical pumping capacity to 5m, horizontal discharge to 50m or a lesser combination of both. Sanivite has also been remodelled to give sound reduction.
Sanivite takes waste from: Washbasin Bath Shower Power shower Washing Machine Dishwasher Sink Can be fitted with Sanialarm
Product Data: Sanivite
Motor
induction motor (no carbon brushes or gears to wear out). Tested over 30,000 cycles.
Watts (Consumption)
360w
Electrical Supply
220-240V 50Hz
Flow rate at max head l/min
50
Horizontal Discharge
50 metres
Vertical Discharge
5 metres
Gravity fall on horizontal installations
1:100
Discharge Pipe Diameter
32mm
Working Temperature
35oC
Maximum Temperature
60oC
Materials
Polypropylene, C.R.P., stainless steel, Neoprene
Motor RPM
2800 RPM
Dimensions (vertical height is measured from floor level)
373W x 350 O/H x 185D
Technote
When used with a shower or bath, the shower tray or bath outlet has to be raised 15 cm above the floor.
As the function of the units is to pump waste and water away, it should not usually be necessary to dig up the floor to lay the discharge pipework. It is possible to run the pipework from low level to a higher level e.g. from a basement to ground floor level, or from 1st floor up into a roofspace and then join to a soil stack